Plasma Cutting Infinity Plasma 40 230V

The cutting cycle is started by a pilot arc, which is established between the mobile electrode and the nozzle/hood of the torch by the short circuit current between these two elements: this technology also enables, other than continuous cutting, cutting of grids and/or perforated sheet metal. Furthermore, adjustment of the current from the minimum to maximum allows you to ensure a high quality cut as the thickness and type of metal varies.

• Suitable for cutting all conductor materials up to 15mm.
• Light and compact. Easy to transport.
• Torch voltage control device.
• Warning led for torch under voltage. 
• Air pressure, torch short-circuit control device.
• Change consumables signal. Automatic torch cooling.
• Air pressure display
• Thermostatic protection: A heat-sensing system that shuts down the machine if the temperature rises too high, preventing overheating.
• Overvoltage protection: Protects the machine from higher than normal voltage levels, which can damage the electronics or the internal parts of the machine.
• Undervoltage protection: It comes into operation when the supply voltage is too low, thereby helping to maintain the stable operation of the equipment.
• Overcurrent protection: Limits current through the machine to prevent overloading or damage to electrical components.
• Contained consumption thanks to inverter technology: Thanks to inverter technology. Inverter technology consumes moderate current in welding machines because it makes the conversion of electrical energy more efficient. Inverter welding machines convert high-frequency AC (alternating current) electrical signals into DC (direct current) signals and then back into AC signals at the desired voltage and current level. This process allows finer control of voltage and current, reducing energy consumption and unnecessary heat generation. In addition, the inverter technology increases the performance and efficiency of the welding machine.

Standard accessories

• Plasma cutting torch
• Fitting for compressed air connection (where applicable)
• Earth cable

Operating modes

• Metal continuous cutting mode.
• Maintained arc cutting mode also when not transferred to the piece (cutting on perforated metal sheets or grids).
• Gouging mode, suitable for use with the torch with GOUGING consumables (removal, modelling of metal by melting).

The advantage of inverter plasma cutting systems is that they are more efficient and accurate than traditional transformer systems, as the output power can be better controlled, thus improving the quality of the cut. The use of compressed air is an added advantage, as there is no need to purchase expensive or special cutting gases, and the system can be simpler and more cost-effective to operate.

Specifications

• Single phase mains voltage: 230V
• Mains frequency: 50/60Hz
• Current range: 10-40A
• Max current: 40A@20%
• Max no load voltage: 313V
• Max absorbed current: 29A
• Max absorbed power: 4kW
• Efficiency: 85%
• Power factor: 0,7
• Max cutting thickness: 15mm
• Compressed air capacity: 100L/Min.
• Compressed air pressure: 4-5Bar
• Protection degree: IP23
• Dimensions: 55x14,5x24
• Weight: 6,48kg